Exports from North Rhine-Westphalian engineering are suffering

Düsseldorf –  Compared to the previous year’s figures, exports were down 8.6 per cent in the first quarter and 23.1 per cent in the corona-affected second quarter.

16 Sep 2020

Valk Welding strategy appears to be the right choice

Alblasserdam – Over the past 40 years, the Valk Welding Group has deliberately chosen to focus on the "general industry" and not on the "automotive industry" and its suppliers.

16 Sep 2020

Raising the EU climate target must not slow down the green steel production

Berlin – Today, the President of the EU Commission, Ursula von der Leyen, announced an increase in the European climate target of a 55 percent reduction in greenhouse gases by 2030.

16 Sep 2020

Bosch and Weichai Power increase efficiency of Weichai truck diesel engines

Stuttgart/Weifang, China – Bosch and the Chinese engine manufacturer Weichai Power have made a huge leap forward in engine technology.

16 Sep 2020

Stelco Provides Further Details on Blast Furnace Upgrade Project

Hamilton - Upgrade and reline project of Lake Erie Works facility is supposed to create the first smart blast furnace of its kind in North America.

15 Sep 2020

China about to build up further state reserves of raw materials

Frankfurt - Supposedly this is a reaction to the corona virus and the deteriorating relations with the USA and its allies.

15 Sep 2020

Miory Steel produced first cold strip coil

Düsseldorf – On August 6, 2020, the first coil was successfully rolled on the new reversing cold rolling mill (RCM), supplied by SMS group, at Miory Steel-

 

15 Sep 2020

wire and Tube will be held from 7 to 11 December 2020

Düsseldorf – Messe Düsseldorf creates all the requirements for holding successful and hygiene-conforming trade fairs in COVID-19 times.

15 Sep 2020

Latin America shows signs of a slow recovery in steel production

Sao Paulo –  Latin America is one of the regions most affected by the COVID-19 pandemic, which resulted in a severe economic crisis.

15 Sep 2020

The route from bar stock to precision components

Achern – The manufacturing service provider microart specialises in the production of precision components in small and large batches

14 Sep 2020

Aperam announces change in the organization of the Leadership Team

Luxembourg - Aperam announces a change in the organization of the Leadership Team, effective from September 14th

14 Sep 2020

Steel organizations mourn for Prof. Dr.-Ing. Dieter Ameling

Düsseldorf – Prof. Dr.-Ing. Dieter Ameling, from 1998-2008 Executive Board Member of the Steel Institute VDEh and from 2000-2008 also Chairman of the Steel Institute VDEh and President of the German Steel Association, died on September 4, 2020. He turned 79 years old.

12 Sep 2020